The Swimsuit Dryer Care and Maintenance Guide
Swimsuit Dryer
Care and maintenance guide
The Swimsuit Dryer is designed to be low maintenance and highly reliable. A few minutes a week is all it takes to keep it running perfectly for years.
The basics
Keeping it clean is as simple as 1, 2, 3.
1
Keep it clean inside and out
The removable top cover makes accessing the inner liner effortless. A quick wipe inside and out is all that is needed weekly.
2
Test the RCD or GFCI monthly
The safety device underneath the unit should be tested once a month. It takes 30 seconds and confirms the unit is operating safely.
3
Check it starts and stops cleanly
The unit should start and stop instantly every time. If it hesitates, or if it is over 5 years old, contact us for a service check.
Video guide
Watch the aftercare walkthrough
A short video covering the full cleaning routine from the Swimsuit Dryer Company.
Maintenance schedule
What to do and when
All tasks use the cleaning equipment supplied with your Swimsuit Dryer. No additional products are needed.
Monthly
RCD / GFCI safety test
30 seconds
1
Locate the RCD or GFCI device underneath the Swimsuit Dryer unit.
2
Press the Test button. The switch should flip to the OFF position.
3
Flip the switch back to ON. If the switch does not respond as expected, contact us immediately before using the unit again.
Weekly
External and basket clean
About 1 minute
1
Spray the outside of the unit with the supplied Swimsuit Dryer cleaner and wipe down with a clean cloth.
2
Lift the lid and spray inside the basket, then use the bottle brush to clean around the inside of the basket.
3
Place a damp cloth inside the basket and run the unit once to clear any remaining cleaning solution.
Do not pour liquid directly into the unit at any time.
Monthly
Deep clean with top cover removed
About 5 minutes
1
Remove the lid screws using the special screwdriver supplied with your unit.
2
Spray inside the unit with the Swimsuit Dryer cleaner, then use the bottle brush to clean around the inside and outside of the basket and inner liner.
3
Check inside the inner liner for any small items that may have been left behind. Remove anything found.
4
Re-fit the lid and tighten the screws. Place a damp cloth inside the basket and run the unit once to rinse through any cleaning solution.
Do not pour liquid directly into the unit at any time.
Safety
Monthly RCD and GFCI check
This is the most important maintenance task. It takes 30 seconds and confirms your unit is electrically safe.
Press Test. Switch flips to OFF. Flip back to ON.
The Residual Current Device (RCD) or Ground Fault Circuit Interceptor (GFCI) is located underneath the unit. Simply press the Test button each month. The switch should immediately flip to OFF. Flip it back to ON and the unit is confirmed safe. If this does not happen, stop using the unit and contact us before operating it again.
Need support or have a question?
If something does not seem right with your Swimsuit Dryer, get in touch and we will help you sort it out.
+60 16-381 5528